Genuine Bosch bevel gear — part number 2610015042 — direct replacement for the bevel/angle drive in compatible Bosch table saws. This precision-formed bevel gear (bevel-cut teeth profile) is made to Bosch’s factory tolerances from hard plastic to restore smooth, low-backlash transfer of motion between angled shafts (used in blade tilt/drive assemblies) and to eliminate play, noise or slipping caused by a worn or damaged gear.

Fits (example models): Bosch GTS 10 J and GTS 1031 table saws — listed as the replacement bevel gear in factory parts lists and exploded diagrams for those models. Verify fit by matching the tool’s full type/model number on the rating plate to your parts diagram before installing.

What you get: one original Bosch bevel gear (2610015042, also shown as 2 610 015 042), ready to drop into the existing gear assembly with no case modifications required. It’s intended to restore factory alignment and reliable tilt/drive operation when the original bevel gear is worn, chipped or stripped.

(Installation note: replace any worn mating gears or bushings at the same time if they show excessive wear to avoid premature wear of the new bevel gear.)